Event Transmission Control Unit
EVENT TRANSMISSION CONTROL UNIT - ERROR ON TRANSMITTING MESSAGE
For a complete wiring diagram Consult Diagrams/Electrical.
- When Monitored:
Ignition on and battery voltage greater than 10 volts.
- Set Condition:
An active DTC is stored in the EGS Module. One Trip Fault. Three good trips to turn off the MIL.
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Initial Inspection and Diagnostic Overview.
Diagnostic Test
1. DTC PRESENT IN TRANSMISSION CONTROL MODULE
This is an informational DTC letting you know that a DTC(s) is stored in the Transmission Control Module or a CAN Bus Failure occurred.
Using a scan tool, read the Transmission Control Module DTCs and perform the appropriate Diagnostic Procedure.
ECM Diagnostic Information complete.
Continue
- Test Complete.