Installation

INSTALLATION





1. Position fan drive belt on water pump pulley.
2. Position fan drive belt on crankshaft pulley.

NOTE: Use only wire ties with nylon locks, not metal.

3. Working from the back side of the crankshaft pulley, insert a nylon wire tie, 196.8mm X 3.175mm X 12.7mm ( 7.75 in. X 0.125 in. x.50 in), through one of the holes in the pulley.
4. Use a nylon wire tie to hold fan drive belt in place.
5. Tighten the wire tie to hold the drive belt in position.
6. Using a suitable tool, rotate crankshaft pulley clockwise
7. Make sure fan drive belt is fully seated.
8. Install radiator fan Radiator Fan - Installation.