9000 - 9999: 9554

9554-OCCUPANT RESTRAINT CONTROLLER PIN 89/90 NOT CONFIGURED

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
With the ignition on.

- Set Condition:
This DTC will set if the module detects a loose or damaged contact, contamination or corrosion or incorrect coding.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.

Diagnostic Test

1. DETERMINE ACTIVE OR STORED DTC
NOTE: Ensure that the battery is fully charged.

NOTE: The scan tool, SRS Airbag Load Tool MRL 8443, and DVOM are required to perform the following test.

Turn the ignition on.
With the scan tool, read ORC DTC.
SELECT ACTIVE or STORED DTC:

ACTIVE DTC

- Go To2

STORED DTC

- Perform *RESTRAINTS SYSTEM INTERMITTENT TEST. Restraints System Intermittent Test.

2. INSPECT FOR DAMAGE

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

Inspect the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Check power and ground circuits. Reconnect any disconnected components and harness connectors and ensure all harness connectors are properly seated.
Were any of the above conditions present?

Yes

- Repair as necessary.
- Perform *RESTRAINT VERIFICATION TEST. Restraints System Verification Test
No

- Go to 3

3. OCCUPANT RESTRAINT CONTROLLER (ORC) CODING
Using the scan tool, perform Occupant Restraint Controller (ORC) Manual Variant Coding for vehicle application.
With the scan tool, read DTC's.
Is the DTC still active?

Yes

WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take proper precautions could result in accidental airbag deployment and serious or fatal injury.
Replace the Occupant Restraint Controller (ORC).
- Perform *RESTRAINT VERIFICATION TEST. Restraints System Verification Test
No

- Test Complete.