Rear Cable

REAR PARK BRAKE CABLE





1. Push each cable end through the brake cable support plate hole (2) until the cable end fitting tabs lock into place. NOTE: Pull on the cable to ensure it is locked into place.

2. Install the rear cables (1) into the park brake lever behind the rear of the brake assembly (3).





3. Install the hold down brackets for the park brake cable (2AND3).





4. Install the cable (3) to the intermediate cable connector (4).
5. Release and remove the lock out device.

6. Perform the park brake adjustment procedure, Adjustments.
7. Remove the supports and lower the vehicle.