B147B

B147B-CHANNEL 6 AUDIO SPEAKER OUTPUT CIRCUIT HIGH





For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

- Set Condition:
The detects a short to battery condition on the output circuit.





1. CHECK FOR AN INTERMITTENT CONDITION
1. Turn the ignition on, then off and then on again.
2. With the scan tool, read the Amplifier DTCs.

Does the scan tool display active: B147B-CHANNEL 6 AUDIO SPEAKER OUTPUT CIRCUIT HIGH?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. CHECK FOR VOLTAGE ON THE (X206) AMPLIFIED RIGHT REAR DOOR SPEAKER (+) CIRCUIT




1. Turn the ignition off.
2. Disconnect the C1 harness connector.
3. Disconnect the Amplified Right Rear Door Speaker harness connector.
4. Turn the ignition on.
5. Measure for voltage on the (X206) Amplified Right Rear Door Speaker (+) circuit.

Is the voltage above 10.0 volts?

Yes

- Repair the (X206) Amplified Right Rear Door Speaker (+) circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. CHECK FOR VOLTAGE ON THE (X296) AMPLIFIED RIGHT REAR SPEAKER SPEAKER (-) CIRCUIT




1. Measure for voltage on the (X296) Amplified Right Rear Door Speaker (-) circuit.

Is the voltage above 10.0 volts?

Yes

- Repair the (X296) Amplified Right Rear Door Speaker (-) circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the.
- Perform the BODY VERIFICATION TEST. Body Verification Test.