B222A

B222A-VEHICLE LINE MISMATCH

For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
The ORC checks its feature configuration for a stored Model Year, Vehicle Line, Country Code, and Body Style continuously 12 seconds after initialization.

- Set Condition:
This DTC sets when the ORC detects a mismatch between the Vehicle Configuration and the ORC configuration.





1. DETERMINE ACTIVE OR STORED DTC

NOTE: Make sure the battery is fully charged.

1. Turn the ignition on.
2. Wait 12 seconds, with the scan tool, read all active ORC DTCs.

Is the DTC active or stored?

ORC - ACTIVE DTC

- Go To 2

ORC - STORED DTC

- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.

2. CHECK THE FCM COUNTRY CODE, VEHICLE LINE AND BODY STYLE
1. With the scan tool, check for the correct Country Code, Vehicle Line and Body Style.

Does the Vehicle Configuration in the FCM match the Vehicle Configuration in the ORC?

Yes

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the ORC.
- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.

No

- Configure the Totally Front Control Module (FCM).