Occupant Restraint Controller (ORC)

U0002-CAN C BUS OFF PERFORMANCE

For a complete wiring diagram refer to the Wiring Information Electrical Diagrams.

- When Monitored:
The ORC checks for serial data message traffic at power up during the initialization process, and continuously through the ignition cycle.

- Set Condition:
This DTC sets when the ORC fails to detect serial data message traffic for more than 5 seconds. In the event the ORC detects serial data message traffic, this DTC will immediately transition to stored status.





1. DETERMINE ACTIVE OR STORED DTC

Is the DTC active or stored?

ORC - ACTIVE DTC

- Go To 2

ORC - STORED DTC

- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.

2. REPLACE OCCUPANT RESTRAINT CONTROLLER

When this code is set, view repair.

Repair

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the ORC.
- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.