Front Hub and Bearing - Removal

REMOVAL

1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the brake caliper and rotor Brake Rotor - Removal.
4. Remove the ABS wheel speed sensor if equipped, Front.
5. Remove the halfshaft nut 4X4 only.

NOTE: Do not strike the knuckle with a hammer to remove the tie rod end or the ball joint. Damage to the steering knuckle will occur.





6. Pull down on the steering knuckle to separate the halfshaft from the hub/bearing. 4X4 only
7. Remove the three hub/bearing mounting bolts (3) from the steering knuckle (4).
8. Slide the hub/bearing (1) out of the steering knuckle (4).
9. Remove the brake dust shield (5).