B2206

B2206-CURRENT VIN MISSING/MISMATCH

- When Monitored:
During power-up, the Occupant Restraints Controller (ORC) monitors the CAN bus for the VIN message.

- Set Condition:
This DTC will set if the VIN information received from the PCM is different from the stored VIN.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.

1. CHECK FOR ACTIVE DTC

NOTE: Troubleshoot any Ignition, Battery, Seat Weight Sensor, or OCM Internal DTCs BEFORE proceeding.

NOTE: Ensure that the battery is fully charged.

1. Turn the ignition on.
2. With the scan tool, read the active ORC DTCs.

Does the scan tool display active: B2206-CURRENT VIN MISSING/MISMATCH?

Yes

- Go To 2

No

- Erase code with scan tool, test complete.

2. CHECK THE VIN STORED IN THE PCM
1. With the scan tool, compare the VIN that is stored in the PCM to the VIN of the vehicle's VIN plate.

Does the PCM VIN match the vehicle's VIN?

Yes

- WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the Occupant Restraint Controller.
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Restraints System Verification Test.

No

- Replace and Configure the Powertrain Control Module.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.