Cooling System Filling

COOLING SYSTEM FILLING

1. If removed, install the cylinder block drain plugs. Coat the threads with Mopar(R) Thread Sealant with Teflon.
2. Close the radiator petcock.
3. Fill the cooling system
4. Fill the coolant recovery container to the MAX mark on indicator stick.
5. Start and operate the engine until the thermostat opens (upper radiator hose warm to touch).
6. If necessary, add additional coolant to the coolant recovery container. This is done to maintain coolant level between the MAX and MIN marks. The level in the coolant recovery container may drop below the MIN mark after three or four warm-up and cool-down cycles.