B2204

B2204-ECU CONFIGURATION MISMATCH

For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition switch on.





WCM

NOTE: Before continuing review and check the following conditions:
- Review the repair history of the vehicle. Make sure the vehicle has the correct PCM and WCM installed. Check the part numbers.
- Using a scan tool, ensure the PCM and WCM have been programmed correctly. Compare the PCM VIN to the WCM VIN and make sure the two VINs match.

1. Turn the ignition on.
2. Using the scan tool, clear DTCs.
3. Perform five ignition cycles, leaving the ignition switch on for a minimum of 90 seconds per cycle.
4. Using the scan tool, read DTCs.

Does the DTC reset?

Yes

- Replace and program the Wireless Control Module.NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the WCM.

- Perform the WIRELESS CONTROL MODULE (WCM) VERIFICATION TEST. Wireless Control Module (WCM) Verification Test

No

- The DTC is not active at this time. Test complete.