Front Window Moves About 3 Inches And Quits

FRONT WINDOW MOVES ABOUT 3 INCHES AND QUITS






NOTE: The Driver circuits are shown but the Passenger side is similar.

For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.






1. TEST FOR DIAGNOSTIC TROUBLE CODES
1. Turn the ignition on.
2. With the scan tool, read DTCs.

Does the scan tool display any Power Window related DTCs?

No

- Go To 2

Yes

- Refer to the appropriate diagnostic procedure.
- Perform the BODY VERIFICATION TEST.Body Verification Test ,

2. WINDOW HALL SENSOR A AND SENSOR B SIGNAL CIRCUIT OPEN
1. Disconnect the appropriate Door Module C2 connector.
2. Disconnect the appropriate Window Motor connector.

NOTE: Refer to the schematic at the beginning of this test for cavity pin outs.

3. Measure the resistance of the Window Hall Sensor A Signal circuit between the Motor connector and the Module C2 connector.
4. Measure the resistance of the Window Hall Sensor B Signal circuit between the Motor connector and the Module C2 connector.

NOTE: Both Window Hall Sensor Signal circuits have to open for this test to be valid.

Is the resistance below 2.0 ohms on both Signal circuits?

No

- Repair the Window Hall Sensor Signal circuit(s) for opens.
- Perform the BODY VERIFICATION TEST.Body Verification Test ,

Yes

- Replace the Window Regulator Assembly.
- Perform the BODY VERIFICATION TEST.Body Verification Test ,