B1503

B1503-STEERING WHEEL CONTROL RIGHT SWITCH PERFORMANCE

For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

- When Monitored:
With the ignition on.

- Set Condition:
The Cluster detects the Steering Wheel Control Right Switch active for greater than 20 seconds.





CHECK FOR AN ACTIVE DTC

NOTE: Before performing this procedure, verify that no LIN Bus related DTCs are set in the Cluster. Repair any LIN Bus DTCs first.

NOTE: Verify all Steering Control Module and Multifunction Switch wiring harness connections are properly engaged before proceeding with test.

1. Turn the ignition on.
2. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Replace the Left Steering Wheel Switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.