B1673

B1673-DRIVER COURTESY LAMP CONTROL CIRCUIT LOW





For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

- When Monitored:
Whenever the module is awake and the courtesy lamps are on.

- Set Condition:
When the Driver Door Courtesy Lamp Driver circuit falls below 3.0 volts for over 1450 ms. and the above conditions are met, this code will set.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase the DTCs.
3. Turn the courtesy lamps on.
4. Wait 30 seconds.
5. With the scan tool, read the DTCs.

Does the scan tool display: B1673-DRIVER COURTESY LAMP CONTROL CIRCUIT LOW?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. DRIVER DOOR COURTESY LAMP SHORTED




1. With the scan tool, erase the DTCs.
2. Turn the ignition off.
3. Remove the inner door panel trim. Front Door Trim Panel - Removal
4. Ensure the Driver Door Courtesy Lamp connector is disconnected.
5. Turn the ignition on.
6. Ensure the courtesy lamps are on.
7. Wait one minute.
8. With the scan tool, read the DTCs.

NOTE: When the Door Courtesy Lamp connector is disconnected, The DTC: B1674-DRIVER COURTESY LAMP CONTROL CIRCUIT HIGH will display as Active. This is normal.

Does the scan tool display: B1673-DRIVER COURTESY LAMP CONTROL CIRCUIT LOW as Active?

No

- Replace the Courtesy Lamp.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

Yes

- Go To 3

3. (M43) DRIVER DOOR COURTESY LAMP DRIVER CIRCUIT SHORT TO GROUND




1. Turn the ignition off.
2. Turn the courtesy lamps off.
3. Disconnect the Driver Door Module C5 connector.
4. Measure the resistance between Ground and the (M43) Driver Door Courtesy Lamp Driver circuit in the DDM C5 connector.

Is the resistance below 10,000 ohms?

Yes

- Repair the (M43) Driver Door Courtesy Lamp Driver circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 4

4. (M43) DRIVER DOOR COURTESY LAMP DRIVER CIRCUIT SHORT TO THE (P114) AUTO DAY/NIGHT MIRROR (-) CIRCUIT




1. Measure the resistance between the (M43) Driver Door Courtesy Lamp Driver circuit and the (G920) Memory Select Switch Return circuit in the DDM C5 connector.

Is the resistance below 10,000 ohms?

Yes

- Repair the (M43) Driver Door Courtesy Lamp Driver circuit for a short to the (G920) Memory Select Switch Return circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 5

5. (M43) DRIVER DOOR COURTESY LAMP DRIVER CIRCUIT SHORT TO THE (G920) MEMORY SELECT SWITCH RETURN CIRCUIT




1. Measure the resistance between the (M43) Driver Door Courtesy Lamp Driver circuit and the (G920) Memory Select Switch Return circuit in the DDM C5 connector.

Is the resistance below 10,000 ohms?

Yes

- Repair the (M43) Driver Door Courtesy Lamp Driver circuit for a short to the (G920) Memory Select Switch Return circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Driver Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.