Operation CHARM: Car repair manuals for everyone.

B1789






B1789-HEADLAMP LEVELING MOTOR CONTROL CIRCUIT HIGH





For a complete wiring diagram refer to the Wiring Information. Electrical Diagrams

- When Monitored:
With the Headlamps activated.

- Set Condition:
When the Totally Integrated Power Module (TIPM) detects an HIGH condition.





1. INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTC's.
3. Turn the Headlamps on.
4. With the scan tool, read DTC's.

Does the scan tool display active: B1789-HEADLAMP LEVELING MOTOR CONTROL CIRCUIT HIGH?

Yes

- Go To 2

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test

2. (W13) HEADLAMP ADJUST SWITCH CIRCUIT SHORTED TO VOLTAGE




1. Disconnect the TIPM C4 harness connector.
2. Turn the ignition on.
3. Measure for voltage on the (L13) Headlamp Adjust Switch circuit.

Is the voltage above 10.0 volts?

Yes

- Repair the (L13) Headlamp Adjust Switch circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- Go To3

3. (W13) HEADLAMP ADJUST SWITCH CIRCUIT OPEN




1. Turn the ignition off.
2. Disconnect the TIPM C4 harness connector.
3. Measure the resistance of the (L13) Headlamp Adjust Switch circuit at the TIPM connector.

Is the resistance below 10.0 ohms?

Yes

- Replace the Totally Integrated Power Module (TIPM).
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- Repair the (L13) Headlamp Adjust Switch circuit for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test