Operation CHARM: Car repair manuals for everyone.

B1D0C






B1D0C-DRIVER MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT LOW

For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

- When Monitored:
Continuously.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, erase all DTCs.
3. Operated the Mirror Switch in all directions several times.
4. Cycle the ignition from on to off three times.
5. Turn the ignition on.
6. With the scan tool, read active DTCs.

Does the scan tool display: B1D0C MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT LOW as Active?

Yes

- Go To 2

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded or contaminated terminals. Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. INSPECT MIRROR CONNECTIONS
1. Turn the ignition off.
2. Disconnect the Driver Outside Rearview Mirror connector at the Drivers Door Module harness connector.
3. Inspect the wiring and connectors between the mirror and the Drivers Door Module.

Were there any problems found?

Yes

- Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. MIRROR ASSEMBLY
1. Turn the ignition off.
2. Replace the Drivers Power Mirror Assembly.
3. Turn the ignition on
4. With the scan tool, erase the DTCs.
5. Cycle the ignition from on to off three times.
6. Turn the ignition on.
7. Operated the Mirror Switch in all directions several times.
8. With the scan tool, read the active DTCs.

Does the scan tool display: B1D0C-MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT LOW as Active?

Yes

- Replace the Drivers Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test Complete
- Perform the BODY VERIFICATION TEST. Body Verification Test.