B1E35

B1E35-3RD ROW SEAT RIGHT BACKREST SWITCH CIRCUIT HIGH





For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

- When Monitored:
Continuously.

- Set Condition:
When the Power Folding Seat senses voltage over 4.9 volts on the (P280) Right Seat Recliner Switch MUX circuit for longer than 300 milliseconds, this code will set.





1. DTC PRESENT
1. With the scan tool, record and then erase DTCs.
2. Turn the ignition off, wait 10 seconds, then turn the ignition on.
3. Operate the Seat Recliner Switch several times.
4. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition.
- Perform POWER FOLDING SEAT SYSTEM VERIFICATION TEST. Power Folding Seat System Verification Test.

2. CHECK THE (P280) RIGHT SEAT RECLINER SWITCH MUX CIRCUIT VOLTAGE




1. Disconnect the Right Power Rear Folding Seat Recliner switch connector.
2. Measure the voltage between the (P280) Right Seat Recliner Switch MUX circuit and the (P281) Seat Recliner Switch Return circuit at the Recliner Seat Switch connector.

Choose result:

Over 5.0 volts

- Gain access to and check the (P280) Right Seat Recliner Switch MUX wire in the seat harness for a short to another circuit. If OK, replace the Power Rear Folding Seat Module.
- Perform POWER FOLDING SEAT SYSTEM VERIFICATION TEST. Power Folding Seat System Verification Test.

4.9. volts + or - 0.1 volt

- Replace the Right Power Rear Folding Seat Recliner Switch.
- Perform POWER FOLDING SEAT SYSTEM VERIFICATION TEST. Power Folding Seat System Verification Test.