Satellite Video (SDARV)

U0010-CAN INTERIOR BUS





For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

- When Monitored:
Continuously when the ignition is on.

Battery voltage between 10 and 16 volts.

IOD fuse installed.

- Set Condition:
The Totally Integrated Power Module (TIPM) detects a short to ground on the CAN Interior Bus (125K)(+) circuit or a short to voltage on the CAN Interior Bus (125K)(-) circuit.





VERIFY DTC IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

NOTE: This module will not be able to communicate when this fault is active and therefore will only display this DTC as stored. To diagnose this DTC, use a scan tool and check for DTCs in the TIPM. If DTCs are active, Testing and Inspection Perform the appropriate diagnostic procedure. If no DTCs are active, but there are stored Lost Communication DTCs, Stored Lost Communication DTCs Perform the appropriate No Response diagnostic procedure. If no DTCs are set, perform the BODY VERIFICATION TEST. Body Verification Test.

1. Turn the ignition on.
2. With the scan tool, read active Satellite Video Receiver DTCs.

Is this DTC active?

Yes

- Testing and Inspection Perform the diagnostic procedure for this DTC.

No

- Perform the Stored Lost Communication DTCs diagnostic procedure. Stored Lost Communication DTCs