Driver Door Module (DDM), (DMFL/R)

U0151-LOST COMMUNICATION WITH OCCUPANT RESTRAINT CONTROLLER (ORC)





For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

- When Monitored:
Continuously when the ignition is on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fuse installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Occupant Restraint Controller (ORC) for approximately two to five seconds.





VERIFY THE DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

1. Turn the ignition on.
2. With the scan tool, read the active DTCs.

Is this DTC active?

Yes

- Perform the U0151-Lost Communication with Occupant Restraint Controller (ORC) diagnostic procedure. Totally Integrated Power Module (TIPM)

No

- Perform the Stored Lost Communication DTCs diagnostic procedure. Stored Lost Communication DTCs.