Door Module

U0197-LOST COMMUNICATION WITH HANDS FREE PHONE MODULE





For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

- When Monitored:
Continuously when the ignition is on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fuse installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Hands Free Module (HFM) for approximately two to five seconds.





VERIFY THE DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

1. Turn the ignition on.
2. With the scan tool, read active DTCs.

Is this DTC active?

Yes

- Perform the U0197-Lost Communication with Hands Free Phone Module diagnostic procedure. Totally Integrated Power Module (TIPM)

No

- Perform the Stored Lost Communication DTCs diagnostic procedure. Stored Lost Communication DTCs.