Side Marker Lamp - Removal

REMOVAL

NOTE: The Light Emitting Diode (LED) and printed circuit board for these lamps are serviced only as a unit with the lamp and lens assembly. If any part of these lamps is damaged or ineffective, the entire lamp assembly must be replaced.





1. Disconnect and isolate the battery negative cable.
2. Remove the mirror glass and holder (1) from the mirror housing (2). Outside Rearview Mirror - Removal.





3. Locate the lamp housing (2) within the lower, outboard side of the mirror housing (1).





4. Using a trim stick (1) or another suitable tool, reach into the mirror housing to access and depress the plastic retaining tab (2) integral to the inboard end of the lamp housing far enough to allow the lamp assembly to be pushed out through the mounting hole in the mirror housing toward the front of the vehicle.





5. Pull the lamp assembly (3) out of the mirror housing (1) far enough to access and disconnect the lamp pigtail wire connector (2) from the mirror wire harness and remove the lamp.