A/C Suction Line - Removal

REMOVAL

WARNING: Review safety precautions and warnings before performing this procedure Warning and Caution. Failure to follow the warnings and cautions may result in serious or fatal injury.






NOTE: 4.0L engine shown. Other engines similar.

1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system Refrigerant System Recovery.
3. On models equipped with the rear heating-A/C system, disconnect the A/C suction line from the underbody suction line A/C Underbody Lines - Removal.
4. Remove the air cleaner housing and inlet duct from the engine compartment.
5. Remove the nut (4) that secures the A/C suction line (5) to the A/C compressor (3).
6. Disconnect the A/C suction line from the A/C compressor and remove and discard the O-ring seal and gasket.





7. Remove the bolt (1) that secures the A/C suction line (3) to the right front frame rail (2).





8. Remove the nut (3) that secures the A/C suction line (1) and the A/C liquid line (5) to the A/C expansion valve (2).
9. Disconnect the A/C suction and liquid lines from the A/C expansion valve and remove and discard the washer seals.
10. Separate the A/C liquid line from the tapping block (4) of the A/C suction line.
11. Disengage the A/C suction line from the retaining brackets located near the center of the dash panel and at the rear of the receiver/drier.
12. Remove the A/C suction line from the engine compartment.
13. Install plugs in, or tape over the opened refrigerant line fittings and the compressor and expansion valve ports.