B166F

B166F-RIGHT TRAILER TOW LAMP CONTROL CIRCUIT LOW

For a complete wiring diagram Refer to the Wiring Information.

- When Monitored:
With the ignition on.

- Set Condition:
The Totally Integrated Power Module (TIPM) Detects a LOW condition.





1. INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTC's.
3. Turn on the Right Turn Signal.
4. With the scan tool, read DTC's.

Does the scan tool display active: B166F-RIGHT TRAILER TOW LAMP CONTROL CIRCUIT LOW?

Yes

- Go To 2

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

2. (L674) RIGHT TRAILER TOW LAMP CONTROL CIRCUIT SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the TIPM C6 harness connector.
3. Measure the resistance between ground and the (L674) Right Trailer Tow Lamp Control circuit.

Is the resistance above 10k ohms?

Yes

- Replace the Totally Integrated Power Module (TIPM).
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Repair the (L674) Right Trailer Tow Lamp Control circuit for a short to ground.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test