B17C4

B17C4-RIGHT SIDEMARKER LAMP CONTROL CIRCUIT OVERCURRENT

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously.

- Set Condition:
When the Totally Integrated Power Module (TIPM) detects a OVERCURRENT condition.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the Left Turn Signal on.
4. With the scan tool, read DTCs.

Does the scan tool display active: B17C4-RIGHT SIDEMARKER LAMP CONTROL CIRCUIT OVERCURRENT?

Yes

- Go To 2

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. RIGHT REAR TURN SIGNAL BULB
1. Turn the ignition off.
2. Remove Right Rear Turn Signal Bulb.
3. Inspect the Right Rear Turn Signal Bulb.

Is the inoperative bulb OK?

Yes

- Go To 3

No

- Replace the Inoperative bulb.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

3. (L162) RIGHT SIDEMARKER LAMP CONTROL CIRCUIT SHORT TO GROUND
1. Disconnect the TIPM C4 harness connector.
2. Disconnect the Right Sidemarker Lamp harness connector.
3. Measure the resistance between ground and the (L162) Right Sidemarker Lamp Control circuit.

Is the resistance above 10k Ohms?

Yes

- Go To 4

No

- Repair the (L162) Right Sidemarker Lamp Control circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

4. (L162) RIGHT SIDEMARKER LAMP CONTROL CIRCUIT SHORTED TO VOLTAGE
1. Turn the ignition on.
2. Measure for voltage on the (L162) Right Sidemarker Lamp Control circuit.

Is there any voltage present?

Yes

- Repair the (L162) Right Sidemarker Lamp Control circuit short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Totally Integrated Power Module (TIPM).
- Perform the BODY VERIFICATION TEST. Body Verification Test.