Operation CHARM: Car repair manuals for everyone.

B1B76






B1B76-RIGHT SIDE SATELLITE ACCELERATION SENSOR 2 INTERNAL





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on, the Right Side Impact Sensor 2 is equipped with on board diagnostics to monitor to sensor's internal circuits. If a problem is identified, the sensor sends the Right Side Impact Sensor 2 Internal message to the Occupant Restraint Controller (ORC).

- Set Condition:
This DTC will set if the ORC receives an internal DTC from the Right Side Impact Sensor 2.





1. VERIFY ACTIVE DTC

NOTE: Make sure the battery is fully charged.

1. Turn the ignition on.

Does the scan tool display active B1B76-RIGHT SIDE SATELLITE ACCELERATION SENSOR 2 INTERNAL DTC?

Yes

- Go To 2

No

- Perform the AIRBAG SYSTEM INTERMITTENT TEST. . Airbag System Intermittent Condition Test

2. VERIFY OPERATION OF THE RIGHT SIDE IMPACT SENSOR 2

WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

1. Replace the Right Side Impact Sensor 2.
2. Reconnect the vehicle wire harness to the sensor.
3. Remove any special tools or jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: Turn the ignition on, then reconnect the 12-volt battery. Failure to follow these instructions may result in possible serious or fatal injury.

4. Use the scan tool and erase the ORC stored codes.
5. Turn the Ignition Off, and wait 15 seconds before turning the Ignition On.
6. Wait one minute, and read active codes.

Does the scan tool display active B1B76-RIGHT SIDE SATELLITE ACCELERATION SENSOR 2 INTERNAL DTC?

Yes

- WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the ORC.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. Airbag System Verification Test.

No

- Repair is complete.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. Airbag System Verification Test.