B1BBD

B1BBD-OCM CURRENT CONFIGURATION TABLE UNPROGRAMMED

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
If the Configuration Table is not programmed at the supplier or when the checksum is invalid.

- Set Condition:
This DTC will set if the Occupant Classification Module (OCM) was received unprogrammed from the supplier, the vehicle line was not identified correctly or if the flash procedure was not completed successfully





MODULE CONFIGURATION

Does the scan tool display B1BBD-OCM CURRENT CONFIGURATION TABLE UNPROGRAMMED?

Yes

- Perform the RE-ZERO OCM SEAT WEIGHT SENSORS diagnostic procedure. . Re-Zero OCM Seat Weight Sensors

No

- WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: If the Occupant Classification Module (OCM) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and may result in possible serious or fatal injury.

- Replace the OCM.
- Perform the RE-ZERO OCM SEAT WEIGHT SENSORS. . Re-Zero OCM Seat Weight Sensors