B1E69

B1E69-DRIVER MIRROR FOLD CONTROL CIRCUIT OPEN





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously.

- Set Condition:
When the Driver Door Module (DDM) senses that the (P694) Driver Mirror Fold Driver circuit or the (P691) Driver Mirror Unfold Driver circuit is open for more than 10 ms.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase Diagnostic Trouble Codes (DTCs).
3. Operate the Mirror Fold switch several times.
4. Cycle the ignition from on to off three times.
5. Turn the ignition on.
6. With the scan tool, read DTCs.

Does the scan tool display DTC B1E69-DRIVER MIRROR FOLD CONTROL CIRCUIT OPEN?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Repeat the test with the mirror adjusted in several different positions. If the DTC is now active, Go To 2. Otherwise, use the wiring diagram/schematic as a guide and inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST. Body Verification Test.

2. CHECK (P694) DRIVER MIRROR FOLD DRIVER CIRCUIT AND (P691) DRIVER MIRROR UNFOLD DRIVER CIRCUIT FOR AN OPEN




1. Turn the ignition off.
2. Disconnect the Driver Outside Rearview Mirror (Component Side) connector from the DDM C2 connector.
3. Measure the resistance between the (P694) Driver Mirror Fold Driver circuit and the (P691) Driver Mirror Unfold Driver circuit at the Driver Outside Rearview Mirror (Component Side) connector.

Is the resistance below 15.0 ohms?

Yes

- Replace the Driver Door Module (DDM).
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Repair the (P694) Driver Mirror Fold Driver circuit or the (P691) Driver Mirror Unfold Driver circuit for an open. If the wiring harness and connector are okay, replace the Driver Outside Rearview Mirror.
- Perform BODY VERIFICATION TEST. Body Verification Test.