B2142

B2142 IGNITION OFF DRAW (IOD) FUSE NOT PRESENT

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the Ignition on. This DTC will set only if vehicle has less that 50 miles on it. After 50 miles, DTC B219F will set.

- Set Condition:
IOD Fuse not installed in the TIPM.





1. CHECK FOR ACTIVE DTC
1. With the scan tool, record and erase DTCs.
2. Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.
3. With the scan tool, read the active DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2. IOD FUSE INSTALLED
1. Verify IOD Fuse installed in TIPM

Is IOD Fuse present?

Yes

- Go To 3

No

- Install the IOD Fuse.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

3. IOD FUSE BLOWN CHECK

Is IOD Fuse blown?

Yes

- Replace the IOD Fuse.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete.