Occupant Restraint Controller (ORC)

B2205-ORIGINAL VIN MISSING/MISMATCH

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

- Set Condition:
The Occupant Restraint Controller (ORC) will receive and monitor the VIN message from the ECM/PCM and record the VIN if different from the last VIN.





1. VERIFY THAT DTC B2205-ORIGINAL VIN MISSING/MISMATCH

NOTE: Make sure the battery is fully charged.

1. Turn the ignition on.
2. With the scan tool, read ORC DTC.

Does the scan tool display active DTC B2205-ORIGINAL VIN MISSING/MISMATCH?

Yes

- Go To 2

No

- Perform the AIRBAG SYSTEM INTERMITTENT TEST. . Airbag System Intermittent Condition Test

2. CHECK VIN IN ECM/PCM
1. With the scan tool compare the VIN that is programmed into the ECM/PCM to the VIN on the vehicle.

Does the VIN programmed into the ECM/PCM match the vehicles VIN?

Yes

- WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the ORC.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. Airbag System Verification Test.

No

- Replace the ECM/PCM and then perform the appropriate verification test procedure.
- Powertrain Verification Test Perform the 42RLE TRANSMISSION VERIFICATION TEST procedure.