Vehicle Theft Security Siren - Installation

INSTALLATION





1. Position the alarm siren module (4) to the engine compartment side of the front end module carrier (3), just below the inboard side of the right front combination lamp unit housing (2).
2. From the front of the vehicle, install and tighten the screw that secures the siren to the carrier. Tighten the screw to 14 Nm (10 ft. lbs.).
3. Reinstall the grille panel (1) onto the front of the vehicle. Grille - Installation.
4. Reconnect the front end module wire harness connector (5) to the connector receptacle of the siren.
5. Reconnect the battery negative cable.

NOTE: If the alarm siren module has been replaced with a new unit, a diagnostic scan tool MUST be used to initialize and configure the new unit in the intrusion module before the Vehicle Theft Security System (VTSS) can operate as designed. Follow the programming steps outlined in the diagnostic scan tool for INITIALIZE SIREN under MISCELLANEOUS FUNCTIONS for the INTRUSION TRANSCEIVER MODULE/ITM menu item as appropriate.