Mirror Lamp - Installation

INSTALLATION

NOTE: The Light Emitting Diode (LED) units and printed circuit board for these lamps are serviced only as a unit with the lamp and lens assembly. If any part of these lamps is damaged or ineffective, the entire lamp assembly must be replaced.





1. Position the lamp assembly close enough to the bottom of the mirror housing (1) to access and reconnect the mirror wire harness connector (3) to the lamp connector receptacle.
2. Position the lamp assembly to the bottom of the mirror housing with the forward flange (4) engaged behind the mirror front cover (2) and the rear flange (5) engaged in the lower rim of the mirror housing.





3. Using hand pressure, push the lamp assembly upward into the mirror housing (1) far enough to engage the latch tab (4) on the lamp housing (3) with the slot in the lower, outboard side of the mirror housing.
4. Position the front cover to the mirror housing.
5. Install and tighten the three screws (2) that secure the front cover to the mirror housing. Tighten the screws securely.
6. Reinstall the mirror glass and case into the mirror housing. Outside Rearview Mirror - Installation.