D. Replace the HVAC Control Head Module

NOTE:
The new HVAC Control Head Module does not require programming.

1. Disconnect negative battery terminal.





2. If equipped, remove the Alternating Current (A/C) electrical power outlet bezel (Figure 1).





3. Remove the small rubber cover on the bottom of the storage tray located above the radio (Figure 2).

4. Remove the retaining screw located behind the A/C electrical power outlet bezel (Figure 1).

5. Remove the two retaining screws in the storage tray located above the radio (Figure 2).

6. Unsnap the bezel assembly from the dash panel.

7. Disconnect all of the electrical connectors from the dash bezel and remove the bezel from the vehicle.

8. Remove the four (4) HVAC control head module retaining screws.

9. Remove and discard the original HVAC control head module.

10. Place the new HVAC control head module into position.

11. Install the four (4) HVAC control head module retaining screws.

12. Place the dash bezel into position and connect all of the electrical connectors.

13. Snap the dash bezel assembly onto the dash panel.

14. Install the two retaining screws located in the storage tray located above the radio (Figure 2).

15. Install the retaining screw located behind the A/C power outlet (Figure 1).

16. Install the small rubber mat located on the bottom of the storage tray (Figure 2).

17. Install the A/C electrical power outlet bezel (Figure 1).

18. Connect the negative battery terminal.