Front Hub and Bearing - Installation

4X4










1. Install the brake dust shield (2).
2. Install the hub/bearing (1) into the steering knuckle (3) and tighten the bolts to 163 Nm (120 ft. lbs.).

3. Install the brake rotor and caliper Brake Rotor - Installation.
4. Install the ABS wheel speed sensor if equipped Front.
5. Install the upper ball joint nut to the steering knuckle and tighten to 54 Nm (40 ft. lbs.), then add an additional 90° turn).
6. Install the tie rod end nut to the steering knuckle and tighten to 61 Nm (45 ft. lbs.) then add an additional 90°.
7. Install the halfshaft nut and tighten to 251 Nm (185 ft. lbs.).
8. Install the wheel and tire assembly Removal and Replacement.
9. Remove the support and lower vehicle.