Differential Carrier - Installation

INSTALLATION






NOTE: If differential bearings or differential case are replaced, Refer to adjustments for Differential Bearing Preload and Gear Backlash procedures.

1. Install Spreader W-129-B (2) with Adapters 8142A (1) and install the safety hold-down clamps. Tighten spreader turnbuckle finger-tight.
2. Install Stud L-4438 in the left side of the differential housing. Attach Dial Indicator C-3339A to a stud. Load indicator plunger against the opposite side of the housing and zero the indicator.
3. Spread housing, while measuring the distance with the dial indicator.CAUTION: Never spread housing over 0.50 mm (0.020 in). Failure to follow these instruction will damage the housing.

4. Remove dial indicator.





5. Install differential case (2) in the housing (1). Ensure differential bearing cups (3) remain in position on the bearings and the differential preload shims are seated in the housing. Tap differential case to ensure bearings cups are seated in the housing.
6. Install bearing caps to their original locations and loosely install cap bolts.
7. Remove housing spreader.
8. Tighten the bearing cap bolts to 61 Nm (45 ft. lbs.).
9. Install axle shafts.
10. Apply a bead of orange Mopar Axle RTV sealant or equivalent to the housing cover.

CAUTION: If cover is not installed within 3 to 5 minutes, the cover must be cleaned and new RTV applied. Failure to follow these instruction will cause a leak.

11. Install cover and tighten bolts in a criss-cross pattern to 23 Nm (17 ft. lbs.).
12. Fill differential with lubricant.