P/U

6.7L DIESEL - P/U




CATALYTIC CONVERTER 6.7L - DIESEL - P/U





1. Position DOC onto the turbocharger. Install clamp finger tight.
2. Using new gaskets position NAC (6) onto the DOC (4) and Diesel Particulate Filter (DPF).
3. Install DOC to NAC and NAC to PDF flange nuts. Tighten nuts to 54 Nm (40 ft. lbs.).
4. Install differential pressure tube support nut (1). Tighten nut to 5 Nm (44 in. lbs.).
5. Install flexible differential pressure tubing (2).
6. 4X4 Vehicles - Install transmission crossmember. Crossmember - Installation
7. 4X4 Vehicles - Install transfer case skid plate.Skid Plate - Installation
8. Check the exhaust system for contact with the body panels. A minimum of 25 mm (1.0 in.) is required between the exhaust system components and body/frame parts. Make the necessary adjustments, if needed.
9. Lower the vehicle.