Pick Up Models

PICK UP MODELS










NOTE:
Threads of NEW Oxygen (O2) sensors are factory coated with anti-seize compound to aid in removal.DO NOT add any additional anti-seize compound to threads of a new oxygen sensor. Be careful not to get anti-seize compound on sensor tip.

1. Inspect the O2 sensor wiring boot for cuts, tears or damage.
2. If the O2 sensor is going to be reinstalled, apply pressurized shop air directly into center hole (1) of O2 sensor.
3. Wipe excess soot off the O2 sensor with a soft cloth.





4. Install the O2 sensor. Tighten to 41 Nm (30 ft. lbs.).
5. Connect the O2 sensor harness connector.
6. Lower vehicle.
7. Connect both negative battery cables.