91DC

91DC-OCCUPANT RESTRAINT CONTROLLER CONNECTOR FAULT

For a complete wiring diagram Refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

- Set Condition:
This DTC will set if the module detects a unused terminal shorted.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.TEST FOR DTC
1. With the scan tool, read active DTC's.

WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

2. Inspect the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Check power and ground circuits. Reconnect any disconnected components and harness connectors and ensure all harness connectors are properly seated.

Were any of the above conditions present?

Yes

- Repair as necessary.
- Perform *RESTRAINT VERIFICATION TEST Restraints System Verification Test

No

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the Occupant Restraint Controller (ORC).
- Perform *RESTRAINT VERIFICATION TEST Restraints System Verification Test