Occupant Restraint Controller (ORC)

950C-OCCUPANT RESTRAINT CONTROLLER PIN 61/62 NOT CONFIGURED

For a complete wiring diagram Refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

- Set Condition:
This DTC will set if the module detects a loose or damaged contact, contamination or corrosion or incorrect coding.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.

1. DETERMINE ACTIVE OR STORED DTC

NOTE: Ensure that the battery is fully charged.

NOTE: The scan tool, SRS Airbag Load Tool MRL 8443, and DVOM are required to perform the following test.

1. Turn the ignition on.
2. With the scan tool, read ORC DTC.

SELECT ACTIVE or STORED DTC:

ACTIVE DTC

- Go To 2

STORED DTC

- Perform *RESTRAINTS SYSTEM INTERMITTENT TEST. Restraints System Intermittent Condition Test.

2. INSPECT FOR DAMAGE

WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

1. Inspect the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Check power and ground circuits. Reconnect any disconnected components and harness connectors and ensure all harness connectors are properly seated.

Were any of the above conditions present?

Yes

- Repair as necessary.
- Perform *RESTRAINT VERIFICATION TEST Restraints System Verification Test

No

- Go to 3

3. OCCUPANT RESTRAINT CONTROLLER (ORC) CODING
1. Using the scan tool, perform Occupant Restraint Controller (ORC) Manual Variant Coding for vehicle application.
2. With the scan tool, read DTC's.

Is the DTC still active?

Yes

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the Occupant Restraint Controller (ORC).
- Perform *RESTRAINT VERIFICATION TEST Restraints System Verification Test

No

- Test Complete.