Programmable Special Module (PSM)

9113-OUTPUT 19 CIRCUIT PERFORMANCE

For a complete wiring diagram, Refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the Ignition Switch in the on position and the Programmable Special Module (PSM) is awake.

- Set Condition:
This code will set when the Output terminal or corresponding circuit is shorted to ground or overloaded for at least 10ms.





1. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase DTCs
2. Turn the ignition on and activate Output.
3. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform the BODY VERIFICATION TEST Body Verification Test

2. COMPONENT SHORTED TO GROUND
1. Turn the ignition off.
2. Disconnect the corresponding component harness connector.
3. Turn the ignition on and activate Output.
4. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

No

- Replace the corresponding component.
- Perform the BODY VERIFICATION TEST Body Verification Test

Yes

- Go To 3

3. OUTPUT SHORTED TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the corresponding PSM harness connector.
3. Turn the ignition on.
4. Measure for voltage on the Output circuit.

Is there any voltage present?

Yes

- Repair the Output circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST Body Verification Test

Yes

- Go To 4

4. OUTPUT CIRCUIT SHORTED TO GROUND
1. Turn the ignition off.
2. Measure the resistance of the Output circuit between the corresponding component and the corresponding PSM connector.

Does the ohm meter read open circuit?

Yes

- Repair the Output circuit for a short to ground.
- Perform the BODY VERIFICATION TEST Body Verification Test

No

- Replace the Programmable Special Module (PSM).
- Perform the BODY VERIFICATION TEST Body Verification Test