9000 - 9999: 9463

9463-OCCUPANT RESTRAINT CONTROLLER CONNECTOR FAULT

For a complete wiring diagram Refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

- Set Condition:
This DTC will set if the module detects a connection failure.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.TEST FOR DTC
1. Turn the ignition on.
2. With the scan tool, erase all DTC's.
3. With the scan tool, read DTC's.

Does the scan tool display this DTC?

Repair

- WARNING: Turn the ignition off, disconnect the battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Check power and ground circuits. Reconnect any disconnected components and harness connectors and ensure all harness connectors are properly seated. Repair as necessary.
- Perform *RESTRAINT VERIFICATION TEST Restraints System Verification Test