Rear A/C Condenser Fan - Installation

INSTALLATION

NOTE: Be certain that each of the rear condenser air seals are installed in their proper locations on the rear A/C condenser. These air seals are required for the rear A/C system to perform as designed.





1. If replacing the rear A/C condenser, install new seals around the edge of the condenser to assure a good seal between the condenser and the rear condenser fan unit (1).
2. If removed, install the two condenser fan brackets (3 and 5).
3. Install the rear condenser fan unit onto the two condenser fan brackets and the two condenser mounting brackets (4 and 7).
4. Install the six washers and nuts (2 and 6) that secure the rear condenser fan unit to the top of the vehicle. Tighten the nuts securely.





5. Connect the two wire harness connectors (1) on the left side rear condenser mounting bracket (2).
6. Install the rear condenser cover to the top of the vehicle and install the retaining screws. Tighten the screws to 2 Nm (17 in. lbs.).
7. Reconnect the negative battery cable.