Instrument Cluster Bezel - Removal

REMOVAL

WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.





1. Using a trim stick C-4755 or equivalent, separate the clips and remove the center bezel.
2. Remove the screws (2) and remove the air outlet covers (1) from the instrument panel center section.





3. Remove the side air nozzles (1), Air Outlet - Removal.










4. Remove the steering wheel, Removal.





5. Remove the instrument cluster (2) Instrument Cluster - Removal.





6. Remove the steering column opening cover, Steering Column Opening Cover - Removal.
7. Unscrew the ignition switch bezel (3), Ignition Switch - Removal.
8. Remove the screws (2) and remove the bezel (1).