Dome/Reading Lamp - Installation

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

NOTE: On vehicles equipped with the optional Roof Control Module (RCM) (also known as the Overhead Control Panel/OCP control unit or DBE) the front dome/reading lamps are integral to the RCM on the headliner near the windshield.





1. Align the base of the bulb with the bulb holder (2).
2. Push the bulb straight into the bulb holder until the base is fully seated.
3. Align the bulb holder and bulb with the keyed opening in the circuit board of the Roof Control Module (RCM) (1).
4. Insert the bulb holder and bulb straight into the circuit board until the bulb holder is firmly seated.
5. Rotate the bulb holder clockwise about 30 degrees on the circuit board to lock it into place.
6. Reinstall the RCM onto the headliner. Roof Control Module - Installation.
7. Reconnect the battery negative cable.