Center Bezel Lamp - Installation

LAMP

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the center bezel lamp (1) to the mounting hole in the center bezel above the forward storage bin of the center floor console.
2. Reconnect the wire harness connector to the lamp connector.
3. Engage the fixed retainer (2) of the lamp with one edge of the mounting hole in the center bezel.
4. Push the opposite end of the lamp upward until the retaining latch (4) snaps into the mounting hole.
5. Reconnect the battery negative cable.