Fuel Pump Module - Removal

REMOVAL

WARNING: The fuel system is under a constant pressure, even with the engine off. Before servicing the fuel pump module, the fuel system pressure must be released.





1. Drain and remove fuel tank. Fuel Tank - Removal
2. Note rotational position of module before attempting removal. An indexing arrow is located on top of module for this purpose.
3. Position Lock ring Remover/Installer 9340 (3) into notches on outside edge of lock ring (5).
4. Install 1/2 inch drive breaker bar (1) to Lock ring Remover/Installer 9340 (3).
5. Rotate breaker bar counter-clockwise to remove lock ring.
6. Remove lock ring. The module will spring up slightly when lock ring is removed.
7. Remove module from fuel tank. Be careful not to bend float arm while removing.