Seat Leg Retracting Cable - Installation

INSTALLATION





1. Feed the cable (2) through the bracket located near the base of the rear leg. Be sure the eyelet (2) is towards the rear of seat.
2. Feed the cable through the rear foot. The cable must run underneath the pivot shaft (3) at the base, and route up through the rear foot. Leave slack in the cable at this time.





3. Attach the spring (2) to the rear leg (3).
4. Attach the cable (1) to the spring.





5. Install the pulley (1) onto the bracket.

NOTE: Spray white lithium grease (p/n 04318066AB) on the pulley and cable where they contact each other.

6. Position the cable into the groove on the pulley.





7. Position the cable to the front leg (1) and install the cable end clip (2).










8. Position the cable housing (1) onto the bracket located near the base of the rear leg (3) and install the retaining clip using a screwdriver or other flat bladed tool (2).





9. Position the cable to the bottom of the seat and install a plastic retaining strap (1).





10. Inspect the retracting leg shields for an embossed DO NOT LIFT symbol (1). If the symbol is not present, replace the retracting leg shields.










11. Install the retracting leg shields (1). Seat Leg Retracting Shield - Installation
12. Install the seat. Seat - Installation