B1859

B1859-DRIVER WINDOW POSITION SENSOR POWER SUPPLY HIGH







- When Monitored:
Whenever the power is turned off to the module and it goes from being awake to sleep mode.

- Set Condition:
When the Driver Window Hall Sensor Supply circuit is above 1.5 volts for over 15 ms. and the power to the module has been turned off, this code will set.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, erase all DTCs.
3. Operate the Driver Window up and down several times.
4. Wait 30 seconds.
5. With the scan tool, read the active DTCs.

Does the scan tool display this DTC?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. (Q305) DRIVER WINDOW HALL SENSOR SUPPLY CIRCUIT SHORTED TO VOLTAGE




1. Turn the ignition off.
2. Disconnect the Driver Door Module C4 harness connector.
3. Turn the ignition on.
4. Measure the voltage of the (Q305) Driver Window Hall Sensor Supply circuit.

Is there any voltage present?

Yes

- Repair the short to voltage in the (Q305) Driver Window Hall Sensor Supply circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Driver Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.