B1870

B1870-ALL DOOR SECONDARY LOCK CONTROL CIRCUIT HIGH







- When Monitored:
Continuously.

- Set Condition:
When the (P390) Secondary Door Lock Relay Control circuit does not change from high to low for over 10 seconds, this code will set.





1. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, erase all DTC's.
2. Lower the Drivers window.
3. Cycle the ignition from on to off and then back to on.
4. Close all doors and operate the door locks in lock and unlock position several times. Pause momentarily in between cycles to allow the secondary locks to operate.
5. With the scan tool, read DTC's.

Does the scan tool display this DTC?

Yes

- Go To 2

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

2. (P390) SECONDARY DOOR LOCK RELAY CONTROL CIRCUIT SHORT TO VOLTAGE




1. Turn the ignition off.
2. Disconnect the Secondary Door Lock Relay.
3. Disconnect the TIPM C7 harness connector.
4. Turn the ignition on.
5. Measure the voltage between ground and the (P390) Secondary Door Lock Relay Control circuit.

Is there any voltage present?

Yes

- Repair the (P390) Secondary Door Lock Relay Control circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the Totally Integrated Power Module (TIPM).
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test