Washer Fluid Level Switch - Removal

REMOVAL

1. Disconnect and isolate the battery negative cable.
2. Hoist and support vehicle on hoist or jack stands.
3. If necessary, remove the right front wheel and tire assembly Tires and Wheels - Removal.
4. Disconnect the right front wheelhouse splash shield and move aside Splash Shield - Removal.
5. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the front (outboard) washer pump port allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front washer pump.
6. Disconnect the electrical body harness connector to the fluid level sensor. Slide the red lock on the connector to the release position, then, depress the black tab and pull the connector off the sensor.
7. Remove the sensor from reservoir by using a side foot to gently pry the sensor from the body of the reservoir. Do not damage the reservoir/sensor sealing surface or puncture reservoir during removal.

CAUTION: Do not rotate the sensor during removal.