Front Display (DISP)

B210E-BATTERY VOLTAGE HIGH



- When Monitored:
At all times.

- Set Condition:
Anytime the Radio Display Module (DISP) senses voltage input above 16.0 Volts, this code will set.





1. CHECK POWERTRAIN CONTROL MODULE (PCM) or ENGINE CONTROL MODULE (ECM) DTCs
1. Using the scan tool, read PCM/ECM DTCs.

Are there any Charging or Battery DTCs present?

No

- Testing and Inspection and perform the appropriate diagnostic procedure.

No

- Go To 2

2. TEST FOR INTERMITTENT CONDITION
1. Using the scan tool, record and erase DTCs
2. Start the engine and run for two minutes.
3. Using the scan tool, read Radio Display Module (DISP) DTCs.

Does the scan tool display B210E-BATTERY VOLTAGE HIGH?

Yes

- Replace the Radio Display Module (DISP).
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test.